Views: 0 Author: Site Editor Publish Time: 2022-04-29 Origin: Site
Before installation, please turn on the water supply source, remove impurities, sand, etc. in the piping, and then turn off the water supply source.
The main purpose is to prevent the Wall Mounted Basin Faucet from being blocked. If there are impurities in the water pipe and cannot supply water normally, it will be quite troublesome to rework and install again. Lock the flange cover into the thread of the water inlet elbow, then wrap the thread with a seal tape, lock it into the wall piping, adjust the hot and cold water inlet elbow, rotate the angle to the same level and the hole distance is the same as the main body.
The distance between the water inlet holes is the same, and then the flange cover is rotated and attached to the wall, mainly to play a fixed role. Put the rubber gasket into the connecting nut of the hot and cold water inlet of the main body, and then connect and lock it with the hot and cold water inlet elbow. Please use a 30mm wrench. Fix the body into the wall, and connect the water inlet pipe. The depth of the buried wall of the Wall Mounted Basin Mixer body should be carefully controlled.
After the wall is completed, the thickness of the tiles and other decorations should be between 45 and 60. Be careful not to bury it too deeply, otherwise it will affect the normal installation and appearance of the faucet. A protective cover should be used during installation to prevent dust from damaging the surface of the Wall Mounted Basin Faucet, and the protective cover cannot be removed until the installation of the handle is completed.
