Bathroom Brass Faucet Installation Method

Bathroom Brass Faucet Installation Method

1. Before replacing the Bathroom Brass Faucet, we must first turn off the water inlet valve. However, if the valve cannot be closed or the valve is not closed tightly, it can also be operated with water, but it should be noted that when installing the new Brass Faucet Tap Mixer, it should be prepared in advance with 7-8 circles pipe tape according to the direction of the thread. A large bucket should be prepared under the water pipe to collect water to prevent waste; in addition, when the valve cannot be turned off, be sure to turn on a new Brass Faucet Tap Mixer and other Bathroom Brass Faucet to divert and reduce the water pressure in advance.

2. To disassemble the Bathroom Brass Basin Faucet Mixer, we can use a wrench to separate the water inlet pipe and the hose. Next, we're going to separate the Brass Basin Faucet Mixer from the basin, and we're going to remove the faucet's fitting parts so that the faucet can be removed from the basin. But then there is a problem. Because the hose of the Brass Basin Mixer has been used for a long time, the hose is generally prone to be embrittlement, and the fitting parts are rusted and cannot be unscrewed with a wrench. Finally, use a saw to cut off the part that is difficult to remove because of rust, and the faucet is successfully removed.

3. Install Bathroom Basin Faucet . First put the hose inside the Basin Mixer and connect it. Then connect the screw rod to the Basin Mixer interface, put the rubber ring on the Brass Basin Mixer, then extend the Brass Basin Mixer into the basin, add rubber pads and gaskets. Finally fix the screw with a wrench.